ATC Diversified Electronics 655 Series Panel Mounted Digital Timer

Looking for a different Industrial Timer?

The 655 Series timer from Automatic Timing and Controls is an electronic control that will retrofit most round case electromechanical timers. the control performs the same timing modes (ON-Delay or Reverse Start Delay) as electromechanical units, and it is capable of timing ranges from 1 millisecond to 199 hours, 59 minutes. On the bottom inside of the control are DIP switches which can be set, in seconds, to establish the timing mode and time range. Our unit will plug into competitive mounted cases without wiring changes in most instances. Remove the electromechanical timer, set ours, plug it into the electromechanical timer case and you’re ready to run. DIP switch setting instructions for electromechanical timers are supplied with 655 installation instructions.

Features:

• Direct Replacement For Electromechanical Timers
• Two Timing Modes
• Data Retention with EEPROM Memory or Battery
• Five Time Ranges
• Simple Keypad Time Setting
• Sealed Faceplate
• Keypad Lockout of Time Setting
• Easy Programming
• Instantaneous Contacts Directly Track the Control Input
• 655-8-3000 timer (data retention memory with lithium battery) now replaced by model 655-8-5000 fit, form & function
• 655-8-3001 timer (data retention memory with lithium battery) now replaced by model 655-8-5001 fit, form & function
• 655-8-2000 timer (data retention memory with EEPROM circuitry) now replaced by model 655-8-4000 fit, form & function
• 655-8-2001 timer (data retention memory with EEPROM circuitry) now replaced by model 655-8-4001 fit, form & function